Page Comparison

Due to various reasons, the devices registered with WSO2 IoT Server might not be able to communicate with the server continuously. When the device is not actively communicating with the server you need to know of it to take necessary actions, such as checking if the device has any malfunctions and repairing it or checking if the device is stolen.

To get a clear understanding, let's look at how this works in WSO2 IoT Server.

• If the device and the server are actively communicating, the device will be is shown as active.

  Expand
  title Click here to see how the device status is shown in the device management console.
  Image Removed Panel borderColor #11375B bgColor #ffffff borderWidth 2 In the device management console, click View under Devices. You can now see all your registered devices and their device statuses. Image Added

• If the server is unable to communicate with the device for more than 300 secondswithin a defined time period, the device will be is shown as unreachable.

• If the server is still unable to communicate with the device

  for more than 600 seconds

  after a defined time period, the device

  will be

  is shown as inactive

  . 

  .

  Expand
  title Click here to see how the device status is shown in the device management console.
  Panel borderColor #11375B bgColor #ffffff borderWidth 2 In the device management console, click View under Devices. You can now see all your registered devices and their device statuses. Image Added

• If the device starts to communicate with the device after some time, the device status is updated back to active.

...

1. Open the <IOTS_HOME>/conf/cdm-config.xml file and make sure the DeviceStatusTaskConfig is enabled. This configuration is enabled by default.

   Info
   If the DeviceStatusTaskConfig is enabled (or enabled on a node that is in a clustered setup) it will run the status monitoring task in the server. If the configuration is disabled, the server will not monitor the status of the devices.

   Anchor
   step1 step1

   Code Block
   <DeviceStatusTaskConfig> <Enable>true</Enable> </DeviceStatusTaskConfig>

2. Configure the device type to go into the unreachable state and then to the inactive state after a specified time.
   Navigate to the <IOTS_HOME>/repository/deployment/server/devicetype directory, open the <DEVICE_TYPE>.xml file, and configure the fields given below:
   The default configuration in the android.xml file is shown below:

   Code Block
   <DeviceStatusTaskConfig> <RequireStatusMonitoring>true</RequireStatusMonitoring> <Frequency>300</Frequency> <IdleTimeToMarkUnreachable>300</IdleTimeToMarkUnreachable> <IdleTimeToMarkInactive>600</IdleTimeToMarkInactive> </DeviceStatusTaskConfig>

   RequireStatusMonitoring	If the value is set to true, it enables the status monitoring task for the device type. Else it will not monitor the status of the device type. Info For the task to run on the specified device type it must be enabled on the server as shown in step 1 above.
   Frequency	Define how often the server needs to communicate with the device. The value needs to be given in seconds. Make sure to have the value above 60 seconds.
   IdleTimeToMarkUnreachable	Define after how long the device needs to be marked as unreachable. The value needs to be given in seconds.
   IdleTimeToMarkInactive	Define after how long the device needs to be marked as inactive. The value needs to be given in seconds.