Page Comparison

...

Enabling Reliable Messaging

Anchor
Enabling Reliable Messaging Enabling Reliable Messaging

Reliable Messaging can be enabled on two levels:

• Service Level (as discussed here)
• Global Level (in the "sandesha2" module)

5. The Enable Reliable Messaging page appears after clicking Reliable Messaging in the Quality of Service Configuration panel.

Select Yes from the drop-down menu.

6. The current Reliable Messaging Sequence Configuration appears.

Field Descriptions

WS-RM defines a one way sequence. The sender (source) is called the RMS (reliable messaging source) and the receiver (destination) is called the RMD (reliable messaging destination). Therefore for in-out operations, the RM uses two sequences. For request messages the server acts as the RMD and for response messages, the server act as the RMS.

• Inactivity Timeout Interval - The maximum inactive time for any RM session. After the sequence timeout, the RM session is terminated.
• Inactivity Timeout Measure - The unit in which the inactivity timeout interval is specified.
• Sequence Removal Timeout - Shows the interval. If the sequence is inactive during this time period, the sequence is removed from the storage.
• Sequence Removal Timeout Measure - The unit, in which the sequence removal timeout interval is specified.
• Acknowledgment Interval - The time interval that the RMD uses to send the acknowledgments.
• Retransmission Interval - The time interval, after which the RMS retransmits the message if it does not get an acknowledgment.
• ExponentialBackoff - Whether RMS exponentially increases the retransmission time or not.
• Maximum Retransmission Count - The maximum number of retransmits the RMS sends.

7. Modify the configuration if required. Click Finish. Reliable Messaging will be activated for that particular service.

Functions of Buttons:

• Finish - Click "Finish" to submit the current data. When finished, your throttle configuration will be applied and the page will be redirected to the previous page.
• Reset - Click "Reset" to load the last submitted configuration.
• Default - Click "Default" to load the default throttle configuration. If you want to submit those data, you have to click "Finish."
• Clear - Click "Clear" to clear all the text boxes in the UI.
• Cancel - Click "Cancel" to go to the "Deployed Modules" page.

Disabling Reliable Messaging

Anchor
Disabling Reliable Messaging Disabling Reliable Messaging

Execute steps 1 to 4 as shown above.

5. The Enable Reliable Messaging page appears after clicking Reliable Messaging in the Quality of Service Configuration panel.

Select No from the drop-down menu.

6. Confirm your request by clicking Yes.