Page Comparison

...

Parameter Name Description

Log Category

This parameter is used to specify the log category. Possible values are as follows. Following log levels correspond to EI service level logs.

TRACE - This designates fine-grained informational events than the DEBUG.
DEBUG - This designates fine-grained informational events that are most useful to debug an application.
INFO - This designates informational messages that highlight the progress of the application at coarse-grained level.
WARN - This designates potentially harmful situations.
ERROR - This designates error events that might still allow the application to continue running.
FATAL - This designates very severe error events that will presumably lead the application to abort.

Log Level

This parameter is used to specify the log level. The possible values are as follows.

Full: If this is selected, all the standard headers logged at the Simple level as well as the full payload of the message will be logged. This log level causes the message content to be parsed and hence incurs a performance overhead.
Simple: If this is selected, the standard headers (i.e. To, From, WSAction, SOAPAction, ReplyTo, and MessageID) will be logged.
Headers: If this is selected, all the SOAP header blocks are logged.
Custom: If this is selected, only the properties added to the Log mediator configuration will be logged.

Info
The properties included in the Log mediator configuration will be logged regardless of the log level selected.

Log Separator

This parameter is used to specify a value to be used in the log to separate attributes. The , comma is default.

Note
Use only the Source View to add a tab (i.e., by defining the `separator=" "` parameter in the syntax) or a new line (i.e., by defining the `separator=" "` parameter in the syntax) as the Log SeperatorSeparator, since the Design View does not support this.

...

Versions Compared