You can add, edit and delete inbound endpoints via the ESB Management Console. You can also enable/disable statistics as well as enable/disable tracing for inbound endpoints via the Management console.
See the following topics for information on how to manage inbound endpoints via the Management Console
| Table of Contents | ||||
|---|---|---|---|---|
|
| Anchor | ||||
|---|---|---|---|---|
|
Follow the steps given below to add an inbound endpoint.
- Open the ESB management console.
- Click the Main tab on the Management Console and then go to Manage -> Service Bus and click Inbound Endpoints to open the Inbound Endpoints page.
- On the Inbound Endpoints page, click Add Inbound Endpoint to open the New Inbound Endpoint page.
- Specify a name for the inbound endpoint, select the protocol type for the new inbound endpoint , and click Next. This displays all the fields applicable to the new inbound endpoint depending on the protocol type you selected.
- Specify values for all the mandatory fields.
Click Show Advanced Options if you want to configure advanced settings for the inbound endpoint. Available advanced options also depend on the protocol type you selected for the inbound endpoint.
- Click Save. You will see the new inbound endpoint you added displayed under Available Defined Inbound Endpoints on the Inbound Endpoints page.
Following are the protocol types available for inbound endpoints. Click on a required protocol type for information on how to configure the inbound endpoint based on that protocol.