Versions Compared

Old Version 1

changes.mady.by.user Former user

Saved on

compared with

New Version Current

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

The Log mediator is used to log mediated messages. See Logging for For more information on logging in the ESB., see Monitoring Logs in WSO2 Administration Guide. 

Info

The Log mediator is a conditionally content aware mediator.

...

Table of Contents
maxLevel3
minLevel3
locationtop
styleborder:1locationtop
typeflat
separatorpipe

...

Syntax

...

The general parameters available to configure the Log mediator are as follows.

Parameter NameDescription
Log Category

This parameter is used to specify the log category. Possible values are as follows. Following log levels correspond to ESB service level logs.

  • TRACE - This designates fine-grained informational events than the DEBUG.
  • DEBUG - This designates fine-grained informational events that are most useful to debug an application.
  • INFO - This designates informational messages that highlight the progress of the application at coarse-grained level.
  • WARN - This designates potentially harmful situations.
  • ERROR - This designates error events that might still allow the application to continue running.

  • FATAL - This designates very severe error events that will presumably lead the application to abort.

Log Level

 This parameter is used to specify the log level. The possible values are as follows.

  • Full: If this is selected, all the standard headers logged at the Simple level as well as the full payload of the message will be logged. This log level causes the message content to be parsed and hence incurs a performance overhead.
  • Simple: If this is selected, the standard headers (i.e. To, From, WSAction, SOAPAction, ReplyTo, and MessageID) will be logged.
  • Headers: If this is selected, all the SOAP header blocks are logged.
  • Custom: If this is selected, only the properties added to the Log mediator configuration will be logged.
Info

The properties included in the Log mediator configuration will be logged regardless of the log level selected.

Log Separator

This parameter is used to specify a value to be used in the log to separate attributes. The , comma is default.

Note

Use only the Source View to add a tab (i.e., by defining the separator="	" parameter in the syntax) or a new line (i.e., by defining the separator="
" parameter in the syntax) as the Log Separator, since the Design View does not support this.

Properties to be logged by the Log mediator can be added by clicking Add Property. The parameters available to configure a property are as follows.

Parameter NameDescription
Property NameThe name of the property to be logged.
Property Value

The possible values for this parameter are as follows:

  • Value: If this is selected, a static value would be considered as the property value and this value should be entered in the Value/Expression parameter.

  • Expression: If this is selected, the property value will be determined during mediation by evaluating an expression. This expression should be entered in the Value/ Expression parameter.

Value/Expression

This parameter is used to enter a status value as the property value, or to enter an expression to evaluate the property value based on the what you entered for the Property Value parameter. When specifying a JSONPath, use the format json-eval(<JSON_PATH>), such as json-eval(getQuote.request.symbol). For more information on using JSON with the ESB, see JSON Support.

Tip

You can click NameSpaces to add namespaces if you are providing an expression. Then the Namespace Editor panel would appear where you can provide any number of namespace prefixes and URLs used in the XPath expression. 

ActionThis parameter allows the property to be deleted.
Info
titleNote

You can configure the mediator using XML. Click switch to source view in the Mediator window.

...