Page Comparison

An An endpoint is  is a specific destination for a message. To monitor a process of mediation concerning a particular endpoint, you need to enable statistics of that endpoint. Endpoints can be switched on and off as required. This is functionality allows endpoints to be temporarily deactivated to avoid performance issues that result from heavy traffic.

Switching on and off is available only for Defined Endpoints.

...

...

for defined endpoints, which are endpoints saved in

...

the Synapse configuration. You cannot switch off dynamic endpoints, which are saved in the registry.

Anchor
On On

Switching on an endpoint

Follow the instructions below to enable statistics for an endpoint.1. Sign in. Enter your user name and password to log on to activate a defined endpoint by switching it on.

1. Log into the ESB Management Console

...

2. Click on "Main" in the left menu to access the "Manage" menu.

Image Removed

3. In the "Manage" menu, click on "Endpoints" under "Service Bus."

Image Removed

4. The "Manage Endpoints" page appears.

Image Removed

5. Choose the "Defined Endpoints" tab.

Image Removed

6. Select the necessary endpoint from the list and click on the "Switch On" link in the "Action" column.

Image Removed

7. The statistics for the endpoint will be activated.

Switching Off Endpoint

1. Select the necessary endpoint from the list in the "Defined Endpoints" tab and click on the "Switch Off" link in the "Action" column.

Image Removed

...

1. using your username and password.
2. Click Endpoints in the Service Bus section of the Main tab to open the Manage Endpoints page.
   
   Image Added 
3. Click on the Defined Endpoints tab. Then click on the Switch On link of the endpoint you want to activate.
   
   Image Added 

Switching off an endpoint

Use the following instructions to deactivate a currently active defined endpoint.

1. Log into the ESB Management Console using your username and password.
2. Click Endpoints in the Service Bus section of the Main tab to open the Manage Endpoints page as shown in the Switching on an endpoint section.
3. In the Defined Endpoints tab, click on the Switch Off link of the required  endpoint.
   
   Image Added