An endpoint is a specific destination for a message. Endpoints can be switched on and off as required. This is functionality allows endpoints to be temporarily deactivated to avoid performance issues that result from heavy traffic.
Switching on and off is available only for defined endpoints.
Tip
The Defined Endpoints tab shows endpoints saved in synapse configuration. The Dynamic Endpoint tab shows endpoints saved in registry.
Switching on an endpoint
Follow the instructions below to activate a defined endpoint by switching it on.
- Log into the ESB Management Console using your username and password.
- Click Endpoints in the Service Bus section of the Main tab to open the Manage Endpoints page.
- Click on the Defined Endpoints tab. Then click on the Switch On link of the endpoint you want to activate.
Switching off an endpoint
Use the following instructions to deactivate a currently active defined endpoint.
- Log into the ESB Management Console using your username and password.
- Click Endpoints in the Service Bus section of the Main tab to open the Manage Endpoints page as shown in the Switching on an endpoint section.
- In the Defined Endpoints tab, click on the Switch Off link of the required endpoint.
