This documentation is for WSO2 CEP 3.1.0. View the home page of the latest release.

Unknown macro: {next_previous_links}
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Introduction

This sample demonstrates how to filter incoming event attributes and add them to another stream using simple pass-through with WSO2Event adaptor. Because we do not use any execution plan here, there is no Siddhi query.

Prerequisites

See Prerequisites in CEP Samples Setup page.

Building the sample 

Start the WSO2 CEP server with the sample configuration numbered 0001. For instructions, see Starting sample CEP configurations. This sample configuration does the following:

  • Creates <CEP_HOME>/repository/conf/stream-manager-config.xml file, which is used to create the stream definitions for the sample.
  • Points the default Axis2 repo to <CEP_HOME>/sample/artifacts/0001 (by default, the Axis2 repo is <CEP_HOME>/repository/deployment/server).

Executing the sample

  1. Open another terminal, go to <CEP_HOME>/samples/consumers/wso2-event and run ant from there.

    It builds the sample wso2event consumer and executes it.

    Do not close this terminal. It is required to keep the server running and receive events.

  2. Open another terminal, go to <CEP_HOME>/samples/producers/service-stats and run ant from there.

    It builds and runs the wso2event producer, which sends sample service stats to the CEP server.

    To configure host, port, username, password and No. of events, use -Dhost=xxxx -Dport=xxxx -Dusername=xxxx -Dpassword=xxxx -Devents=xx.

    For example : ant -Devents=10

  3. See the output events received from the CEP via the terminal opened in step 2. For example, given below is the console output of the consumer when sending 5 events from the producer.  

  • No labels