Failover Endpoint

The Failover Endpoints send messages to the listed endpoints with the following failover behavior. At the start the first listed endpoint is selected as the primary and all other endpoints are treated as backups. Incoming messages are always sent only to the primary endpoint. If the primary endpoint fails, next active endpoint is selected as the primary and failed endpoint is marked as inactive. Thus, it sends messages successfully as long as there is at least one active endpoint among the listed endpoints. Default fail-over endpoint behavior is dynamic fail-over. ESB switches back to the primary endpoint as soon as it is available.

XML Configuration

Note

You can configure the Failover endpoint using XML. Click on the "Switch to source view" link in the "Failover Group" page.

<failover>
    <endpoint .../>+
</failover>

UI Configuration

1. In the "Add Endpoint" list, click "Fail-Over Endpoint" (See Adding an Endpoint). The "Failover Endpoint" page appears.

Failover Endpoint

2. In the "Endpoint Name" field enter a name for the endpoint.

Failover Endpoint: Set Name

See the detailed information about the Endpoints properties in Adding an Endpoint.

3. Click "Add Endpoint."

Failover Endpoint: Add Child Endpoint

4. A shortcut menu with the available endpoints appears.

Failover Endpoint: Add Child Endpoint Menu

5. Click on the endpoint you want to add as a Failover Endpoint. A tab with the fields relevant to the selected endpoint appears.

Failover Endpoint: With Child Endpoint Form

6. Enter the details (see Address Endpoint, Failover Endpoint, WSDL Endpoint). Click "Save."