Template Endpoint

Template endpoints are created based on predefined endpoint templates. Parameters of the endpoint template used as the target are copied to the endpoint configuration. However, you can make modifications by removing some of the copied parameters and/or adding new parameters.

A template endpoint can be defined following the instructions below.

Note

You can also configure a Template endpoint using XML. Click Switch to source view in the Template Endpoint page.

Open

1. Log into the ESB Management Console. In the Main tab, click Endpoints to open the Manage Endpoints page.

2.  Click Template Endpoint to open the Template Endpoint page.
   

    
   Enter the required values for the following parameters.

3. Click Save and Close to save the endpoint configuration in the Synapse configuration, or click Save in Registry to save it in the Registry.

4. If you clicked Save in Registry, the page will expand to display the Save as Synapse Registry Entry section. Select either Configuration Registry or Governance Registry as relevant to specify the registry in which the endpoint should be saved. Then define a key for the registry entry in the Key parameter.

5. Click Save and Close to save the configuration.